***NO LONGER AVAILAVBLE - END OF LIFE PRODUCT***

Cases, Buttons and Speaker Kit for ODROID-GO

This is a spare mechanical parts pack for ODROID-GO Kit. PACKAGE INCLUDE  B. 1x Front enclosure  C. 1x Back enclosure  E. 1x 4 button rubber  F. 1x 2 button rubber  G. 2x 2 button rubber  H. 1x 8Ohm 0.5W speaker  J. 10x screws  K. 1x LCD window  L. 1x button set Once you have assembled the ODROID-GO, you can download and install the games of yesteryear to play - comfortable in the knowledge that they're on a device you built for yourself!

ASSEMBLY INSTRUCTIONS

This section shows you how you can build the ODROID-GO. Please carefully follow the instruction below.

LCD window

First, in order to protect LCD screen, you have to place the enclosed plastic screen cover on the front enclosure. Please completely remove the sticker on the back of the screen cover and carefully place it on the front enclosure.

LCD screen

Second, you need to attach the 2.4” LCD screen to the front enclosure. Please note that you must remove the vinyl cover on the LCD screen before placing LCD module in the front enclosure. Also, you would need to slightly wipe or blow out the window cover or LCD screen in order to remove any dust or fingerprints.

Play buttons

Third, place the play buttons in the front enclosure. You need to cut and remove the plastic buttons (an arrow key piece, buttons 'A' and 'B') from the plastic button set enclosed, and then put the rubber pieces on top of the plastic keys.

Main board

Next is the main part of the assembling instructions. Please carefully put the ODROID-GO board in the front enclosure and connect the LCD cable to the board. After the LCD screen cable is firmly connected, you can fasten the main board with the screws (3x) enclosed.

You also need to connect the battery pack and speaker module to the ODROID-GO board. It would be a good idea to wrap the speaker wires as shown in the picture, otherwise, it would be difficult to close the back enclosure.

\

Power key

Another piece which you have to cut on the plastic button set is the power key, and you can place the power switch at the side of the ODROID-GO.

Close the back enclosure

Finally, you can close the back enclosure of the ODROID-GO with the screws (6x) enclosed. You can also try to turn on the ODROID-GO before closing the back enclosure.

Testing before playing

You can turn the device on or off with the power switch on the right side of the ODROID-GO. Please softly slide the key up to turn on or down to turn off.

Memory card

If the memory card is not inserted or fails for any reason, you will have an error screen when you turn on the ODROID-GO.